Wish List

Cart

Product Category

LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12
  • LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12
  • LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12
  • LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12
  • LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12
  • LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12

LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12

Price:
$0.00
Quality Grade:
OEM New
Quantity:

(MOQ: 1)

Shipping Fee:

$0.00 By Logistics to Country

Estimated shipping time: 1 - 10 working days
Total:

$0.00

LUBAN Face ID Lattice Dot Projector Repair Programmer For iPhone X-11 Pro Max/iPad A12


For Face ID Not Working Repair | Move iPhone a Little Lower/Higher


Support Models: IP X-11 Pro Max/ iPAD A12

Support Face ID dot projector condition check, and data read & write


Operations

  • Get the Face ID module connected with the Luban programmer, programmer connect with computer
  • Cell phone connect with the computer and get into the recovery mode
  • Install and run the LubanTool software, click the ‘Pearl Unbind’ button to unbind the dot projector

  • Teardown the glass lens after the unbinding process is finished
  • Mark with a cross scratch on the dot projector cable for future better alignment
  • Grinding the metal shielding cover and take out the encrypted little board
  • Remove the MOSFET, capacitor, and the encrypted chip with a hot air gun and special knife
  • Solder the conversation chip on the position of the encrypted chip
  • Then solder the Luban dot projector chip on the surface of the conversation chip
  • Short the MOSFET related pins and solder back the capacitor

  • Get the dot projector flex cable buckled on the Luban programmer then connect with computer and enter into recovery mode
  • Click the ‘Pearl Bind’ button to bind the soldered chip
  • Test with iFace tester again to ensure the dot projector works normally
  • Get the dot projector cable and lens well installed and aligned, apply glue to fix the gap
  • Install the flex cable and test the Face ID function again

Other tools and materials required for LUBAN repair


Face ID Lattice Dot Projector Repair Programmer


________________________________________________________________________________________________________________


Packing

Carton box packing


After Sales Service

Please feel free to contact us for any problem at any time: service@rewa.tech

Contact Us